89
•
Use an extension power cord with an appropriate section depending on its
length
Warning: the connection to a network that does not meet the requirements of
the electrical engine may cause serious damage to some of the components of
the machine. The machine features electrical components (contactors and
differential circuit breakers) that disconnect the power to the engine and to the
system.
To start the electrical engine, and thus the hydraulic pumps, use the ignition
key placed on the ground controls (this part is the same as described in the
paragraph "Starting the internal combustion engine".
Once this phase is complete, turn the switch (6) on the push-button to the
"ELECTRIC ENGINE
”
position. This enables the ignition of the electrical engine
and the 220V power supply to the outlet on the work platform.
To start or stop the electrical engine, select the "ON" lever (
5
) on the console:
4.2.4
Travel controls
The controls used for the movement of the platform are represented by 2
joysticks (10-11) located on the control panel. (see photo below).
Summary of Contents for 1090 EVO
