33
SL1 DATA LOGGER User Manual Rev. AD
ENGLISH
12.5.3 SENDING THE SETUP TO SL1
When the setup is modified, it is important to remember to send it to the SL1 Data Logger to apply
the new settings. Proceed as follows:
•
Connect the SL1 Data Logger to the PC (see
•
Make sure that the correct setup was loaded (see
and
)
•
Press > Set Conf. to send the setup to the SL1 Data Logger:
•
During the procedure for sending the configuration, the red LED flashes a few times which
indicates that the SL1 Data Logger is applying the configuration.
•
At the end of the operation, a message is displayed to indicate that the procedure is complete.
Summary of Contents for GET SL1
Page 1: ...ENGLISH DATA LOGGER User Manual...
Page 15: ...15 SL1 DATA LOGGER User Manual Rev AD sales get athena eu www getdata it ENGLISH 2 Driver...
Page 90: ...90 SL1 DATA LOGGER User Manual Rev AD sales get athena eu www getdata it ENGLISH NOTES...
Page 91: ...91 SL1 DATA LOGGER User Manual Rev AD sales get athena eu www getdata it ENGLISH NOTES...
