10
Assembly
Please note the attached assembly instruction
sheet!
►
Remove the debris container (10) from the device
and remove the accessories bag (15).
►
Turn the device upside down and fasten both circular
brushes (11) to the circular brush fixtures (19) with the
ST3.9 x 16 screws supplied (14).
►
Now turn the device right side up again so it will rest
on the wheels and insert the debris container (10) again.
►
Move the handle hoop (1+2) up and fix it by
pressing it into the handle locks (6+7). Now fasten the han-
dle hoop by tightening both knurled nuts (5).
►
The choice of holes in the upper handle hoop (2) pro-
vides you with three options for height adjustment. Loosen
the two knurled nuts (5) for adjustment and remove the
spacers (4). Now remove the saucer head screws (3). The
upper handle hoop (2) can now be adjusted. Once the right
position has been found, the upper handle hoop (2) is fas-
tened again in the reverse order, starting with the saucer
head screws (3).
Start-up
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
Check that the machine is completely and correctly assem-
bled.
Before each use, check
there are no damages at the machine
whether the debris container, handle hoop and brushes
are firmly mounted
Working with the push sweeper
Firmly hold the device with both hands when working.
Always work on dry, nonskid and flat ground.
Avoid abnormal posture. Provide a safe standing position
and keep at any time the balance.
Push the device over the area to be swept, at normal
walking speed (approx. 4 km/h), ahead of you.
Sweeping only takes place when the device is pushed
forward.
Dirt on edges or in corners is caught and cleaned by
the circular brushes (11).
The working height of the circular brushes (11) can be
adjusted infinitely variable by turning the adjustment
knob (13).
The height of the rear brush roller (22) can be adjusted
by turning the lateral adjustment knobs (12).
Empty the debris container (10) regularly after each
sweeping or when it is full.
Maintenance and Care
Before each maintenance and cleaning work:
-
wait for standstill of the beater
Maintenance and repair work other than those described in this
chapter is only allowed to be carried out by service staff.
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected
damages and injuries.
Maintenance
To guarantee a long and reliable usage of the product carry out
the following maintenance works regularly.
Check the machine for obvious defects such as
loose fixtures
worn or damaged components
correct assembly and faultless covers and protective devic-
es
Necessary repair work or maintenance has to be carried
out before using the power tool.
Care
Observe the following to maintain the operability of the
machine:
Clean all moving parts regularly.
Remove dust and dirt using a soft brush, a dry or wet cloth.
Do not clean the machine with running water or high-
pressure cleaners.
Do not use solvents for the synthetic parts (petrol, alcohol,
etc.) as these can damage the synthetic parts.
Keep handles dry and free of oils and grease.
Water, solvents and polishing agents shall not be
applied.
Storage
Store unused products in a dry, locked place out of the reach
of children.
Empty the debris container (10) each time before it is
stored.
For space-saving storage position the upper handle
hoop (2) in the highest position, loosen both knurled nuts (5),
pull the handle hoop (1+2) upwards, fold the handle hoop
forward and stow the unit vertically.
Before a longer period of storage carry out the following to
extend the machine
’
s service life and ensure an easy operat-
ing:
thoroughly clean the device
