15
−
Do not clean the machine with running water or high-pressure cleaners.
−
−
After each operation treat bare metal parts with an environment-compatible biodegradable spray oil to protect them against corro-
sion.
G
G
u
u
a
a
r
r
a
a
n
n
t
t
e
e
e
e
Please observe the enclosed terms of guarantee.
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
a
a
l
l
f
f
a
a
u
u
l
l
t
t
s
s
Before each fault elimination:
−
Switch off device.
−
Wait for standstill of the garden shredder.
−
Pull out mains plug.
Fault Possible
cause
Removal
Motor does not start.
−
No power supply.
−
Mains cable defective.
−
Upper part of the enclosure not properly
closed (safety shut-off is activated).
−
Check fuses.
−
Have these checked (electrician).
−
Close and bolt down upper part of the enclosure cor-
rectly, remove any dirt present.
Motor hums,
but does not start.
−
Cutters blocked.
−
Capacitor faulty.
−
Switch machine off, disconnect mains plug, and clean
interior of machine.
−
Have machine repaired by manufacturer or approved
company.
Reduced cutting perform-
ance.
Knife edges became blunt.
Turn the knife or replace it with a new set of knives.
Device starts but blocks
under slight load and cuts off
via protective motor switch.
Extension cable too long, or cross-section
too small. Socket too far from mains sup-
ply and cross-section of mains cable too
small.
Extension cable at least 1.5 mm², maximum 25 m long. If a
longer cable is used, minimum cross-section 2.5 mm².
Summary of Contents for MHD 2200
Page 125: ...124 ...
Page 131: ...129 ...
