11
Do not operate machine before having read
the operating instructions, understood all the
notes and assembly the machine as described
here.
Keep the instructions in a safe place for future use.
Contents
Extent of delivery
11
Declaration of conformity
11
Characteristics data of noise
12
Symbols machine /operating instructions
12
Normal intended use
12
Residual risks
13
Safety instructions
13
Description of device / Spare parts
15
Assembly
15
Preparing for commissioning
15
Commissioning
16
Mains connection
16
On / Off Switch
16
Dust/chip exhaustion
16
Adjusting the saw
16
Adjusting the riving knife
16
Set the cutting height
17
Adjust saw blade pitch
17
Fitting and adjusting the transverse stop
17
Fitting and adjusting the longitudinal stop
17
Working instructions
17
Cutting narrow workpieces
17
Cutting wide workpieces
17
Cross cuts / mitre cuts
18
Maintenance and care
18
Maintenance 18
Cleaning 18
Transport
19
Storage
19
Possible faults
19
Technical data
20
Guarantee
20
Extent of delivery
After unpacking, check the contents of the box
!
That it is complete
!
Check for possible transport damage
Report any damage or missing items to your dealer, supplier or
the manufacturer immediately. Complaints made at a later date
will not be acknowledged.
•
Circular saw T 250 N-2 including
−
Power cable and plug
−
TCT saw blade
∅
250 x 1,8/2,8 x
∅
30 mm; 40 teeth
−
Splitting wedge
•
4 table legs
•
2 connecting braces short
•
2 connecting braces long
•
4 push-on bases
•
2 additional braces
•
Safety guard with exhaust outlet
•
Longitudinal stop
•
Table length extension
•
2 supports for bench length extension
•
2 bench width extensions
•
4 supports for table width extensions
•
Pushstick
•
Extraction hose
•
screw bag
•
2 spanners for replacing saw blade
•
Operating manual
•
Assembly and operating instruction sheet
•
Warranty declaration
EC Declaration of Conformity
No. (S-No.): 16208
according to EC directive:
2006/42/EC
We,
ATIKA GmbH
Josef-Drexler-Str. 8
89331 Burgau - Germany
herewith declare under our sole responsibility that the product
Tischkreissäge (Circular Saw Bench)
Model M1H-ZP2-1-250A, Type T 250 N-2
Serial number:
000001 – 020000
is conform with the above mentioned EC directives as well as with
the provisions of the guidelines below:
2004/108/EC and 2011/65/EU
Following harmonized standards have been applied:
EN 61029-1:2009/A11:2010; EN 61029-2-1:2012;
EN 55014-1:2006/A2:2011; EN 55014-2:1997/A2:2008;
EN 61000-3-2:2014; EN 61000-3-3:2013
Duly authorised person for the complilation of technical
documents:
ATIKA GmbH – Technical department
Josef-Drexler-Str. 8 – 89331 Burgau – Germany
i.A.
Burgau, 18.12.2015 i.A. G. Koppenstein,
Engineering design management
