800.261.3602
Revised 07/18
Mounting Instructions
1.
Using a Phillip screw driver loosen the four mounting bracket screws until they reach the stops.
Angle the screws and brackets inward as shown below.
2.
Carefully work the wiring into the wall, and insert the mounting bracket into the opening,
adjust the face plate to be parallel to the wall surface.
3.
Center the controller in the opening against the wall, using a Philips screw driver, tighten each
screw 10 to 14 full turns. This brings the mounting clip evenly toward the wall and face plate.
4.
Adjust each screw until it comes in contact with the wall. Readjust the face plate if needed to
align or center it in the opening. Now tighten all four screws, so that the plate is secure against
the wall. DO NOT over tighten the screws.
10