137
Kullanım Kılavuzu
ATLANTA Xtrend - ET9000
Manual Scan of Services
[ : Press
‘Setup’
‘Service Searching’
‘Manual Scan’]
If you know well enough to configure each exact setting required for manual search of services, you can do manual scan
as well. There are many parameter values that you need to decide as below.
Amongst other things, the below parameters are what you need to decide prior to performing manual scan.
Tuner
You need to decide which tuner you want to use for manual scan.
System
Here you have two options between DVB-S (SD) and DVB-S2 (HD).
Frequency
You need to enter the exact frequency of the transponder that you want to scan.
Symbol Rate
You need to enter the exact symbol rate of the transponder that you want to scan
Polarity
Here, you have options for Horizontal, Vertical, Circular Left and Circular Right. You need to know the polarity of the
transponder that you want to scan.
FEC (Forward Error Correction)
You need to enter the exact FEC value of the transponder that you want to scan
Modulation
Here you have two options for QPSK (SD) and 8PSK (HD).
Network Scan
Here you have two options for
YES
and
NO
.
NO
is used to scan the transponder (TP) based on the data that your
Atlanta Xtrend-ET9000 currently has.
YES
is used to scan the TP not just based on the existing TP data but also using
new TP data, if there is TP data newly transported from the TP. Naturally,
YES
option takes longer while it may results in
a better scan result.
Clear Before Scan
YES
is used when you want to delete the existing channel list before you start the automatic scan. If you want to keep
the existing list, select
NO
.
Only Free Scan
Here you have two options for
YES
and
NO
. You want to scan only Free to Air channels without any encryption, select
YES
. Otherwise, select
NO
to scan all FTA and CAS channels.
For DVB-S (Standard Definition)
For DVB-S2 (High Definition)
