○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
4
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Models T70 LR, T70 C, and T70 SR
speakers in, aiming them at the prime listening position. This can be particularly useful if the LR
speakers are fairly far apart.
The T70 C should be placed directly above or below your television. It’s important that the speaker is
centered on the screen, not off to the side. Place the separate speaker base so that the foot “cutouts”
are closest to the front. Sit the speaker’s feet in the cutouts and tilt the speaker so that it points at the
listening position. Try to keep the T70 C no more than 2 feet higher or lower than the LRs.
Important Note:
Most surround sound decoders and receivers offer a choice of “Normal” or “Wide-band”
or “Large” and “Small” modes for the some or all of the speakers in their setup menus.
All T70 speakers
must be used in the Normal or Small mode, if this choice is available.
Surround Effects
The T70 SR’s size allows great placement flexibility and its unique TriVector spatial characteristics
make it possible to place them almost anywhere within the rear third of the room. The best location
however, is straight out to the sides of the prime listening position (+/- 15 degrees), approximately
18 to 24 inches above ear level. Do not block the sound emanating from the side-mounted tweeters.
Important Note:
The surround speakers are intended to re-create the ambient sounds taking place in the
movie scene. Throughout part or most of a movie you may not be directly aware of the surround speakers’
presence. Try to avoid the trap of turning the surrounds up so loud that you hear them all the time. The result
will be a much less believable surround sound experience.
Figure 2:
Typical wiring
diagram for
speakers in a
home theater.
To optional
second
subwoofer
