ENG
35
5
SNMP intelligent slot (optional).
7
Output receptacles: connect to mission-critical loads
9
Output Terminal Block.
2.2 Setup The UPS
Step 1: UPS input connection
Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using
extension cords.
Step 2: UPS output connection
Simply plug devices to output sockets. During power failure, UPS will provide power
to connected devices.
Step 3: Communication connection
Communication port:
To allow for unattended UPS shutdown/start-up and status monitoring, connect the
communication cable one end to the RS-232 port and the other to the communication
port of your PC. With the monitoring software installed, you can schedule UPS
shutdown/start-up and monitor UPS status through PC. A03-OP2301 and A03-OP3451
models are equipped with intelligent slot perfect for SNMP, RS-232, USB card. When
installing with these communication card in the UPS, it will provide advanced
communication and monitoring options.
PS. USB port and RS-
232 port can’t work at the same time
.
Remove cover of intelligent slot, Insert communication card into the slot and finally
Screw card tightly and complete installation.
