23
P
L
P
B
2
3
1
Standby (
Hors Gel
) Mode
It is the mode enabling to maintain a temperature of approximately 7°C in the room in case of pro-
longed absence from the house.
a) Leave switch
on the Marche position.
b) Set the knob
to
.
Turbo mode
It is the mode enabling to set the device into Forced Operation, ensuring prompt temperature
increase in the room over the time defined (
maximum power for conventional models and fan acti-
vation point for models with ventilating fan).
a) Leave the switch
on the Marche position.
b) Select the time for the Turbo using the knob
.
c) Press the command
, the indicators
and
light.
d) The TURBO mode can be interrupted manually before the end of the time set. In order to do
this, press the command
again.
NB:
For piloted devices, only the heating stop and frost setting instructions are prioritised when
TURBO mode is activated (
the other instructions are inoperative).
Locking commands
It is possible to lock the knob
or restrict its use, preventing untimely handling of the device (
chil-
dren…).
Locking the knob:
a) Set the knob to the position required.
b) Using a small-size flat-blade screwdriver, pull the knob’s cap (1).
c) Detach pin
P
from its stand using a cutting tool.
d) Set pin
P
in the alignment of arrow
B
(2).
e) Refit the cap.
Limitation of the knob’s use range:
a) Using a small-size flat-blade screwdriver, pull the knob’s cap (1).
b) Remove the two
P
pins from their stand using a cutting tool.
c) Position the two
P
pins at each end of the operating range desired (3).
d) Refit the cap.