25
W
ARNING
- Using the bleeder, make sure that the device is correctly filled. If, when you open the bleeder, the
water does not flow regularly, please contact your fitter.
- It is forbidden to leave
c
switch on l when the supply tap
d
is open. This abnormal use causes can-
cellation of the warranty.
- The use of this device without water would lead to the definitive deterioration of the resistor. This
incident would definitely require its replacement, which is not covered by the Maker's guarantee.
- The boiler return tap
a
must obligatorily remain open, even in the case of the SUMMER SETTING
in order to allow expansion of the fluid in the circuit so as to avoid any damage to the device.
- The hot water circuit must necessarily be used to allow the fluid to expand in the heating circuit.
- Children must not lean on the device or play close to it when it is operating : its surface may be hot
enough to cause burns to their skin in some circumstances, particularly because their reflexes may
not yet have been acquired or are slower than those of an adult. If there is any risk, fit a protective
grill in front of the device.
- This device is not intended for use by persons (
including children
) with physical, sensory or mental di-
sability, or by persons lacking experience or knowledge, unless they have received from a person in
charge of their safety adequate supervision or preliminary instructions on how to use the device.
- Prevent children from climbing on the device.
- In order to avoid a hazard for very young children, this device should be installed so that the lowest
heated rail is at least 600 mm above the floor.
- Any intervention on the electrical parts must be performed by skilled staff.
- Do not insert objects or paper in the device.
- Upon first warming, a slight smell may appear, due to the evacuation of compounds used during the
device’s manufacturing.
- The casing may be hot, even when the device is off.
Red indicator
Power off the
heating.
Extract the
filter from the
back of the
machine.
Clean the
filter.
Refit the
filter.
Wait 10 mi-
nutes before
restarting the
heating.
Restart the heating.
M
AINTENANCE
- To maintain the performance of the device, about twice per year, clear the dust.
Do not use abrasive products.
- Use a vacuum cleaner to clear the air inlet and outlet grids, as well as the filter.
The fan is fitted with an antidust filter which, when clogged, can result in its stoppage.
For better use, clean your filter regularly, according to the following instructions:
