background image

1-877-80-PONDS 

www.atlanticwatergardens.com

4494 Orchard Street, Mantua, Ohio 44255 
Phone 330-274-8317, Fax 330-274-8790 
info@atlanticwatergardens.com 
www.atlanticwatergardens.com

Skimmer Accessories

AF1000 AUTO-FILL KIT

  Labeled drill points have been provided for the  
proper Auto-fill location on either side of the Oasis 
Skimmer. See the diagram. It is a good idea to  
completely install the pump, check valve assembly,  
and discharge hose before you drill for the Auto-fill.  
This will help you determine the best side of the  
Skimmer to place the Auto-fill so that  
it has proper clearance on all sides.
  Once you have determined the 
location of the Auto-fill, drill a 7/8” 
hole using a spade bit or hole saw. 
Insert the Auto-fill making sure the 
gasket is on the inside of the skim-
mer and the plastic retaining nut is 
on the outside. Tighten the retain-
ing nut until snug. (Do not over-
tighten the retaining nut.)
  Fittings to connect the Auto-Fill 
to a garden hose, 1/2” irrigation 
line, and 1/2” Sch40 are included in the kit. Wrap the 1/2” male threads on the 
Auto-fill with thread sealant and install the fitting of your choice. Once water 
is supplied to the Auto-fill it will maintain the set water level by automatically 
adding water when the level drops. This level can be adjusted by loosening the 
wing nut and raising and lowering the height of the auto-fill float. Use the water 
line mark on the weir door frame to help establish proper water level.

SKIMMER OVERFLOW

  A drill-point has been provided on the back of the Oasis skimmer to show 
the proper location and elevation to install an Atlantic HA2000 bulkhead fitting 
for the overflow (not included). See diagram above for drill-point location. This 
combination will position the bottom of the overflow pipe approximately 1” 
above recommended water level. (Note: If a HA2000 bulkhead is not being 
used, the center point for the hole will have to be recalculated on site.)
  Drill a 3” hole and install the bulkhead following the instructions on page 8. 
Install a 2” MTA and connect the overflow pipe.  

OVERFLOW

PUMP DISCHARGE

AF1000 AUTO-FILL

VALVE

GASKET

RETAINING 

NUT

FITTING

Reviews: