OnePower UPS 700VA/300W(EN)
A03-PE702 Pag. 19
LED/Button
Information
Main Switch (
)
To Control on/off the UPS when Utility is normal. Push
the "Main Switch" for 3 seconds, then release it when
the LED is extinguished
To enable “DC-Start” Function when Utility fails. (To
enable DC Start properly, you are recommended to
connect <80% output load with the UPS only). P.S.
Make sure the computer connected to the UPS is
switched on before enable the "DC-Start" function. You
are not recommended to add some other computer or
peripherals after DC-Start function is activated.
LED Line (
)
Green LED remains standstill when Utility is normal.
Green LED flashes every 2 seconds and simultaneously
buzzer alarms (beep once every 2 seconds)
continuously when Utility failure.
Green LED flashes once every 0.5 second and
simultaneously buzzer alarms (beep once every 0.5
second) continuously when utility failure and battery is
Low.
Green OFF: to avoid UPS from over-discharge, the UPS
shuts itself down when the battery voltage is too low.
