28
1.6 Connect telephone/LAN surge protection and USB
Connect a single line telephone into the RJ-11/RJ45 telephone surge/LAN
protection “IN” jack on the back of the UPS. Connect from the “OUT” jack with
telephone cable to a fax modem.
Connect the supplied interface cable to the USB computer interface port on the
back of the UPS. Connect to the computer. Download and install software from
. See software document for installation instruction.
1.7 Operation Test
Connect the UPS to the wall receptacle.
Push on the Main Switch, after some seconds LCD Display AC Mode is on.
Connect your computer equipment with sockets of the UPS and pull off the
input power cable of the UPS from the wall receptacle to check the Battery
MODE is on (instead of AC Mode). Meanwhile, please check if alarm buzzer is
beeping every 10 seconds