Stopping the engine, Honda
1. Release the clutch handle (A) completely. Avoid
any slip of the V-belt by releasing it quickly. Let
the engine idle for a few minutes.
A
NOTICE
Reduce the engine speed directly after
the machine stops, to idle speed. It is not
permitted to run the engine with the clutch
activated (except at idle speed).
2. Turn the switch (B) to OFF.
3. Close the fuel cock (C).
Operating
NOTICE
When using the floating disc, be aware of
the position of the blades. All four blades must be
inside the brackets on the floating disc. Also check
the centre position of the floating disc in relation to
the blade cross, to avoid any eccentricity during
rotation.
NOTICE
Observe the concrete surface for loosened
stones during operation. A stone can make marks
on the surface. If this appears during the end of the
operation, when the concrete surface is hard and
close to be finished, the damage can be hard to
restore.
Manoeuvring the trowel
The trowel is manoeuvred by applying force on the
handle in different directions. The procedure below
describes how to move the trowel in different
directions, but just as important is the balance and
smoothness of the operator to achieve smooth and
easy movements of the machine.
17
© 2051 Construction Tools EOOD | No. 9800 1224 01b | 2051-05-18
Original instructions
Safety and operating instructions
BG 240 H4
