<s>
10
• This screen shows the load delay time 10 and the unit <s> seconds. To modify this value
press enter key (1).
• An optional password may be required, the value starts blinking and arrow keys (2) and (3)
can be used to modify the value.
• Press enter key (1) to program the new value, press reset key to cancel.
3.27 Calling up modifying minimum stop time
Control panel
Starting from the Main screen:
bar
6.6
• Press arrow key (2) until <P.11> and the motor pictograph is shown and then press enter
key (1):
<s>
20
• This screen shows the minimum stop time 10 and the unit <s> seconds. To modify this value
press enter key (1).
• The value starts blinking and arrow keys (2) and (3) can be used to modify this value.
• Press enter key (1) to program the new value.
Instruction book
48
API451763
