13
PAGE
Repair Instructions Nr.183.09/00
PHE 50 S
Mounting the
complete sleeve
1
Fasten the spring (2) with the screws (1).
2
Insert the complete sleeve (A) into the
gear housing (B) and take care that the
piston and the sleeve (A) are aligned. If
necessary, align the piston centred
through the gear housing opening.
3
Insert the O-ring (C) into the gear housing.
4
Mount the housing (6) on the gear hous-
ing (B) and tighten down the five
screws (7) with their washers.
5
Insert the O-ring (5), the actuator (4), and
the spring ring (3).
☞
The actuator (4) must be mounted
such that it grasps the groove of the
drive sleeve (F).
6
Fit the gasket (D) and the cap (E) and fas-
ten it with the 4 nuts (9) (torque = 3 Nm)
and the washers.
7
Insert the felt (8).
Mounting the
gear cover
Mounting the
field and the
armature
1
Mount the gear cover (6) and fasten it with
two screws (7) to the gear housing (8).
☞
The two screws (7) must be covered
with screw locking device.
2
Push the armature (5), turning it slightly,
through the gear cover (6) into the gear.
3
Insert the O-ring (B) aligned into the motor
housing (9) and mount the field together
with the motor housing (9). Mind the right
position!
4
Fasten the field with the motor housing (9)
to the gear cover with four screws (4).
5
Mount the brush holders (3) and fix them
with the screws (A).
6
Carefully lift the carbon brush springs on
both sides and insert the carbon brush-
es (2).
Fit the cable lugs (1).
☞
Attention: Mind the mounting position
of the flat spiral spring (C): Pre-tension
the spring 3/4 turn!
6
1
2
7
3
4
5
A
B
C
D E
9
8
B
F
9
1
4
6
2
3
7
8
9
A
5
B
C
10
Summary of Contents for PHE 50 S
Page 1: ......
