When moving the machine a shorter distance, grasp
frame on the power pack's short side, see illustration
below. Pull the machine to its intended destination.
When lifting the power pack with a forklift, fit the lifting
strap in the manner shown in the illustration below.
Operation
WARNING Involuntary start
Involuntary start of the machine may cause injury.
►
Keep your hands away from the start and stop
device until you are ready to start the machine.
►
Learn how the machine is switched off in the event
of an emergency.
►
Stop the machine immediately in all cases of
power supply interruption.
Operating
NOTICE
A new PP 100 is delievered without oil in
the tank. Always fill with hydraulic oil before operating
a new power pack.
♦
Same procedure as in "Hydraulic oil refill".
Preparation before starting
The following checks must be made each time the
power pack is used. All these checks concern the
operation of the power pack. Some concern safety:
♦
Clean all safety labels. Replace the missing or
damaged labels.
♦
Remove dirt and debris.
♦
Inspect the power pack and hoses generally for
signs of damage.
♦
Check that all cables are intact and in a good
condition.
♦
Fill up the hydraulic hoses with oil before start.
♦
Check for oil leakages under the power pack.
♦
Ensure that the hydraulic couplings are clean and
operational.
♦
Check all fastenings.
♦
Place the power pack in a safe position, to prevent
tilting during operation. Maximum 45º tilt. The
prefered position is the hydraulic end as highest
point.
♦
Check that the machine is connected to an earthed
electrical outlet socket, according to instructions
in section "Electrical connection".
© 2016 Construction Tools PC AB | No. 9800 1364 01c | 2016-04-06
Original instructions
14
PP 100
Safety and operating instructions
