8
Fitting the insertion tool
1. Unscrew the tool retainer from the cylinder.
2. Insert the insertion tool into the chuck.
3. Screw the tool retainer onto the cylinder. Tighten it using a hammer.
Start and Stop
Starting the pick hammer
The pick hammer starts when the inserted tool is pushed into the cylinder. Start the
pick hammer by pressing the tip of the inserted tool against the work piece.
Stopping the pick hammer
The pick hammer will stop when the tip of the inserted tool is no longer pressed
against the work piece.
Starting a cut
h
Stand steady and make sure that your feet and hands are at a safe distance from
the inserted tool.
h
Adjust the breaking distance so that the inserted tool does not get stuck. Do not
try to cut too big a bite.
Summary of Contents for Secoroc G10
Page 11: ...11...
Page 12: ...12 Spare parts list and exploded drawing...
Page 14: ...14 NOTES...
Page 15: ...15 NOTES...
