Atlas Copco XAHS365 Md, Instruction Manual

I

NSTRUCTION

 M

ANUAL

11

C

ONTROL

AND

INDICATOR

PANEL

The control and indicator panel is located behind the small panel in
the front service door.

Push buttons and fuses

S1 ...... On/off push button

To switch the voltage on and to stop the engine.

S3 ...... Start push button

To start the engine.

S4 ...... Compressor loading push button

To load the compressor. Once the button is pressed, the
pressure starts building up.

S20 .... Emergency push button

To stop the compressor in case of emergency. This is done by
pushing the red button on the door of the control panel. To reset
the push button, press it and turn it anticlockwise. Use this
button only in case of an emergency.

Gauges

WPG .. Working pressure gauge

P1 ...... Fuel level gauge

P2 ...... Engine oil pressure gauge

P3 ...... Hourmeter

P4 ...... Temperature gauge, engine coolant

P6 ...... Tachometer

Lamps

H1 ......Alternator charging indicator lamp

Goes out after starting, indicating that the alternator is
charging.

H2 ......Low fuel level alarm lamp

Starts flashing when there is only fuel left for approx. half an
hour of operation.

H3. .....Air filter servicing alarm lamp

Starts flashing if the air filter elements need servicing.

H7 ......Engine coolant temperature fault indicator lamp

Starts flashing if coolant temperature is too high.

H8 ......Engine oil pressure fault indicator lamp

Starts flashing if the engine oil pressure is too low.

H9 ......Compressor temperature fault indicator lamp

Starts flashing if the compressor element outlet temperature is
too high.

H10 ....Engine coolant level fault indicator lamp

Starts flashing if the coolant level is too low.

H11 ....Fuel level fault indicator lamp

Lights up if the fuel level is too low.

H13 ....Warming up indicator light

Indicates that the engine is warming up or cooling down

H14 ....Automatic load indicator light

Lights up when automatic load is chosen and the compressor is
waiting for loading.

H15 ....Manual load indicator light

Lights up when the compressor is loaded.

A

DDITIONAL

CONTROLS

AND

INDICATORS

The compressor contains a number of controls and indicators which
are not situated on the control and indicator panel.

H22 ....Flasher light

Located above the front service door. Starts flashing when the
air filters need to be serviced, when there is only fuel left for
half an hour of operation or in case of a shutdown.

SG .....Sight glass oil level

The sight glass is located next to the air receiver and indicates
the oil level in the air receiver.

TG......Compressor element air outlet temperature gauge 

Located behind the front service door and indicates the
temperature of the air at the outlet of the compressor element.

Cont & indic panel