Operation And Use
41
12ASL
8.2.2 Standing
• To rest the vehicle at the desired height by releasing the lifting pedal;
• Place the safety pawl on the nearest safety rack by turning down the safety
lever;
• Lower the jack beam by depressing the lowering pedal on the pump to
engage the safety;
• Check to make sure the mechanical safety is engaged before entering the
work area.
8.2.3 To Lower The Jack Beam
• Be sure the under jack is free of any objects;
• Raise the jack beam a little bit by depressing the lifting pedal;
• Release the mechanical safety by turning up the safety lever;
• Depressing the lowering pedal on the pump until the jack beam is lowered
completely.
8.3 Runway
Leveling
Warning: engage the mechanical safety locks when the vehicle
is left on the runways for long periods (ex. during the night).
During this procedure, DO NOT attempt to raise lift with any load.
After a period of service, due to natural loss of the oil or trapped air in the
hydraulic line, it could be possible that the runway P2 (the slave runway) is
lower than the runway P1 (the master runway). In this case, level the runways
following these instructions:
• Raise the runways to approximately 12”;
• Turn off the leveling cutoff cock N.O;
• Turn on the leveling cutoff cock N.C;
• Lightly push the UP button and then DOWN button to adjust the height of
the runway P2;
• Turn off the leveling cutoff cock N.C and turn on the leveling cutoff cock
N.O after the runway P2 reaches at the same height as the runway P1.
