STEP 7:
Guide the bead breaker shaft through the pivot pin (on the breaker arm). Install the
locknut using a socket wrench and extension. If an extension is not available to you,
you may pull the breaker shaft outward to access the shaft and nut with a wrench.
STEP 8:
Use the locking handle to lock the hex shaft into place. Remove the bolt and cap from
the top of the hex shaft. Set the cap and bolt nearby.
STEP 9:
Slide the coil spring over the hex shaft. Push the spring downward and install the cap
and bolt (removed in step 8) to hold the spring into place.
Summary of Contents for Atlas TC221
Page 1: ......
