23
The angle of the mount/demount head is preset to accommodate rim sizes from 12” to 18”. If the
rim size is out of this pre-set range, an adjustment to the angle of the mount/demount head must
be made. To adjust the mount/demount head angle:
STEP 1:
Lock the wheel on the turntable. (using the movable jaws)
STEP 2:
Loosen the retaining bolt under the mounting head but do not remove.
STEP 3:
Lower the hex shaft (7, Fig3) until the
mounting head (6, Fig3) rests next to the
wheel rim and on top of the wheel. Move the
locking lever back to lock the hex shaft. The
mounting head will rise up approximately
2mm.
STEP 4:
Loosen the adjusting screws on the side of the mounting head.
STEP 5:
Adjust the angle of the mounting head by hand. Maintain 2mm clearance from the
edge of the wheel.
STEP 6:
Tighten the adjusting screws.
STEP 7:
Release the locking lever and allow the hex shaft to rise. Move the locking lever back
to lock the hex shaft. Tighten the retaining bolt under the mounting head.
