REV. 01 2012
17 / 35
6.3.2.2 ALU
ƿ
ƿ
MODES
x
Move the A/D gauge to the position
“
1
”
as shown in the figure 18, select and press
SELECTOR to confirm. The dimensions A1 and D1 are set automatically, and a beep sound is
heard in the meantime. The set dimensions are shown on the screen after releasing the gauge.
x
Move the AD gauge to the position
“
2
”
as shown in the figure 19. Two seconds later, the
dimensions AE and DE are set automatically, and a beep sound is heard in the meantime. The
set dimensions are shown on the screen after releasing the gauge.
The positions
“
1
”
and
“
2
”
are determined by the operator according to the rim
profiles. The distance between two positions must be more than 2.5 inch. Failure
to do so, the measurements cannot be correct.
6.3.3
MANUAL SETTINGS OF DIMENSIONS
Wheel dimensions can also be set manually as follows:
x
Turn SELECTOR to select and press SELECTOR to enter the program for setting of
wheel dimensions.
x
Press SELECTOR to change the white dot to red
color and to change the corresponding dimension
text from grey to yellow (ref. fig. 20).
x
Continue to turn SELECTOR until the correct
dimension is selected.
x
The unit for diameter and width of the rim can also
be changed to mm or inch by turning and pressing
SELECTOR to change the white dot under the
dimensions to red.
x
Press SELECTOR to save the dimension and then
continue to set other dimensions.
Fig. 20
Fig. 19
Fig. 18
Summary of Contents for WB55
Page 1: ......
Page 35: ...REV 01 2012 35 35 CHAPTER 12 ELECTRIC DIAGRAM...