REV. 01 2012
19 / 35
Tips (ref. fig. 24):
x
Select and press SELECTOR to show the
fine readings of unbalanced amounts.
x
Select and press SELECTOR to convert
the reading units (gram or ounce).
x
Select and press SELECTOR to show the
unbalanced positions of the rim in 3D graph.
6.4.2 STATIC MODE
The static modes are used for narrow wheels when it is not possible to place the counterweights on
both sides of the rim. Apply a single weight on one of sides of the rim
or in centre of wheel according to the diameter of the wheel mounted.
The program of this machine has two static modes: STA1 and STA2
(ref. fig. 25).
x
STA1 mode is used to clip the weights on the rim for correction.
x
STA2 mode is used to apply the adhesive weights on the rim for
correction.
To perform the static balancing, do as follows:
x
Select STA1 or STA2.
x
Measure and set the wheel dimensions
automatically or manually.
x
Start a spin.
x
After the spin is completed, the unbalanced amount
will be shown on the screen (ref. fig. 27).
x
Following the arrow direction, rotate the wheel
slowly by hand until the red dot moves to the 12
o
’
clock position, and the arrow changes to be green
and points to the 12 o
’
clock position (ref. fig. 28).
x
At STA1 mode, clip a correct weight on one of
sides of the rim for correction.
x
At STA2 mode, apply a correct adhesive weight in centre of wheel for correction.
Fig. 24
Fig. 25
Fig. 26
Fig. 28
Summary of Contents for WB55
Page 1: ......
Page 35: ...REV 01 2012 35 35 CHAPTER 12 ELECTRIC DIAGRAM...