REV. 01 2012
26 / 35
To make the weight calibration, select and
press SELECTOR and then proceed as the diagram
shown on the screen (fig. 50):
x
Mount a wheel with average dimensions on the
shaft. Be sure the wheel is not mounted with any
weight.
x
Set the wheel dimensions of the wheel mounted
automatically or manually.
x
Perform the first spin under normal condition
x
Rotate the wheel manually to the position marked
with the dot on the inner rim and apply 100g
weight on the position (ref. fig. 52) .
x
Start the second spin.
x
After the spin is finished, remove the 100g
weight from the rim.
x
Rotate the wheel manually to the position marked
with the dot on the outer rim and apply 100g
weight on the position (ref. fig. 53) .
x
Start the thrid spin.
x
After the spin is finished, a beep can be heard for
three times and then the program of the weight
calibration exits automatically.
x
Remove the 100g weight from the wheel.
x
Press STOP/ESC key to exit.
Fig. 50
Fig. 51
Fig. 52
Fig. 53
Summary of Contents for WB55
Page 1: ......
Page 35: ...REV 01 2012 35 35 CHAPTER 12 ELECTRIC DIAGRAM...