REV. 01 2012
8 / 35
CHAPTER 3
–
TRANSPORTATION, UNPACKING AND STORAGE
3.1 TRANSPORTATION
x
The machine must be transported in its original packaging
and kept in the position shown on the package itself.
x
The packaged machine may be moved by means of a fork lift
truck of suitable capacity. Insert the forks at the points shown
in figure 2.
3.2
UNPACKING
x
Remove the protective cardboard and the nylon bag.
x
Remove the fixing bolts from the packing pallet.
x
Check that the equipment is in perfect condition, making sure that no parts are damaged or
missing. Use fig. 1 for reference.
If in doubt do not use the machine and contact your retailer.
3.3 STORAGE
Packages must be stored in a covered place, out of direct sunlight and in low humidity, at a
temperature between -10°C and +40°C.
In the event of storage for long periods of time, be sure to disconnect all sources of power and grease
the clamp sliding guides on the turntable to prevent them from oxidizing.
3.4 SCRAPPING
When your machine’s working life is over and it can no longer
be used, it must be made inoperative by
removing any connection to power sources.
These units are considered as special waste material, and should be broken down into uniform parts
and disposed of in compliance with current laws and regulations.
If the packing are not polluting or non-biodegradable, deliver them to appropriate handling station.
Fig. 2
Summary of Contents for WB55
Page 1: ......
Page 35: ...REV 01 2012 35 35 CHAPTER 12 ELECTRIC DIAGRAM...
