Safety
25
Apex-10 / Apex-10H
• Neither remove nor disconnect hydraulic, electric or other safety devices;
• Carefully follow the safety indications applied on the machine and included
in the manual;
• Observe the safety area during lifting;
• Be sure the motor of the vehicle is off, the gear engaged and the parking
brake put on;
• Be sure only authorized vehicles are lifted without exceeding the maximum
lifting capacity;
• Verify that no one is on the arms during lifting or standing.
6.2 Safety
Device
To avoid overloading and possible breakage, the following safety devices have
been used:
• A pressure overload valve built inside the hydraulic power unit to prevent
excessive weight;
The pressure overload valve has been preset by the
manufacturer. DO NOT try to adjust it to overrun the rated
lifting capacity.
• Mechanical safeties built in each carriage with automatic engagement for
lifting safety.
It is strictly prohibited to modify any safety device. Always
check the safety device for proper operation during the use of
the lift.
6.3 Safety
Signs
All safety warning signs displayed on the lift are with the purpose to draw the
operator’s attention to dangerous or unsafe situations. The labels must be kept
clean and they have to be replaced if detached or damaged. Read the meaning
of the labels carefully and memorize it.
Summary of Contents for APEX-10
