Operation Instructions
31
PX-16A
Operation Instructions
To lift vehicle
1. Keep clean of site near the lift, and down the lift to the lowest position.
2. Drive vehicle to the platform and put on the brake.
3. Turn on the power and press the button
UP
, raise the lift to the working
position.
Note:
make sure the vehicle is steady when the lift is rising
4. Press the button
Lock
, lock the lift in the safe position. Make sure the
safety is locked in the same height.
To lower vehicle
1. Be sure clear of around and under the lift, only leaving operator in lift area.
2. Press the button Down, until the lift low down to 24” from ground. Keep
feet clear off lift, push button “DOWN” while push the Lowering Alarm
Button (black) at the side of control cabinet, the lift is lowered to ground
with alarm tone;
3. Drive away the vehicle when the lift is lowered to the lowest position.
4. Turn off the power.
Fig. 38
BUZZER
LOCK
UP
UP
K
DOWN
POWER
SWITCH
RED BUTTON
Summary of Contents for PX-16A
