REV. 03
8 / 22
CHAPTER 4 – COMMISSIONING
4.1 SPACE REQUIRED
When choosing the place of installation, make sure that it complies with current
safety at work regulations.
Do not operate the balancer while it is on the pallet.
x
The balancer must be located on a flat floor of solid construction, preferably concrete. The
balancer must sit solidly on its three feet. If the balancer is not leveled, the balancer will not
function properly and may produce inaccurate balance readings.
x
Select a location for the balancer that provides a level, solid floor, and adequate clearance
around and above the balancer.
The place of installation must also provide at least the space
shown in pictures Fig. 3 and Fig. 4 so as to allow all parts of the machine to operate correctly
and without any restriction.
x
Make sure the location selected has enough room above and behind the machine so the wheel
guard can be raised completely. The location must also provide working room for mounting
and removing wheels. Make sure the area has adequate lighting.
x
If the machine is installed outside it must be protected by a lean-to.
4.2 SHAFT ASSEMBLY
x
Mount the thread end piece (A) onto the shaft by
screwing the retaining screw (B).
x
Tighten the retaining screw (B) thoroughly by
using the supplied wrench (C).
Fig. 3
Fig. 4
Fig. 5
A
B
C
Summary of Contents for WB11
Page 1: ......
