3
Mounting bracket x 2
The HDVS-200-RX comes with mounting brackets that can be used to affix the unit to a table,
desk, etc.
To affix the mounting brackets to the unit, use the four included screws. The bracket can be
affixed with the oval holes pointing to the bottom
(for against the wall - picture A)
or the oval holes
facing the top
(for under tables - picture B)
.
Larger oval
hole will be
attached to
the wall/table.
Mounting
Circular holes
will always be
attached to the
unit.
A
B
The captive screw connectors allow you to cut cables to a suitable length, reducing cable clutter
while providing a more reliable connection.
Captive Screw
Connecting
The captive screw connectors have
a contact bar that is adjusted to
compress the wire against the top
contact plate. Use the screws at the
top of the connector to compress
the wire against the contact plate.
When connecting the cables to the female captive screw connector it is important that the wires be
terminated correctly. The female captive screw connector has a contact plate at the top and must
have the wires touching it for signal to pass. When wired correctly
(see picture A)
the signal will pass,
incorrectly
(see picture B)
no signal will pass.
Clockwise
Counter
Clockwise
Turn the screws clockwise to
raise the contact bar to the
upper contact plate and hold
the wires in place.
Turn the screws counter
clockwise to lower the
contact bar to release the
wires.
A
B
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
