AT-VCC-RELAY
17
Control
4
Press the green + arrow to open the macro options.
5
Set the Device to Velocity Command Converter - Relay.
6 Select the port that will be associated with the
command.
7
Select the state that will be activated with the macro.
8 *Optional* Provide a command name and Alias name.
9
*Only when Split Rooms is enable within Room Options*
Select which room states this event will be active in.
10
Press the save button in the top right corner of the
screen.
In the first example, the Event Macro: Screen Open will close
port 1 of the VCC-Relay to trigger the projector screen to
drop down when the Room On command within Velocity is
used.
In the second example, the Event Macro: Screen Close will
open port 1 of the VCC-Relay to trigger the projector screen
to go back up when the Room Off command within Velocity
is used.
In the first example, the Event Macro is triggered by the
Room Off command, and will only take effect when the room
is Split. This will trigger port 1 of the relay to open and break
the circuit for the connected device.
In the second example, the Event Macro is triggered by the
room mode being set to split room. Room state is not an
option for this triggering event. The room being split will
trigger port 1 of the relay to close and complete the circuit
for the connected device.
NOTE:
These are just general examples for control. The VCC-Relay can be used to control anything
that use relay controls.
NOTE:
On1 and On2 are used when the VCC is
set to Double Pole, Double-Throw. While in this
mode, off will not be functional.
