AT-VCC-RELAY
8
The Atlona AT-VCC-RELAY-KIT is an accessory for the Atlona Velocity™ Control System that provides conversion
between IP control commands and relay / sensor signals. This Velocity Control Converter is very compact and can
be placed anywhere a device requires control and is not IP-capable. The VCC-RELAY-KIT is remotely powered
through Power over Ethernet (PoE), or locally from a USB power source. The primary unit installs onto any surface
via a convenient mounting dock. A simple “click” locks it into place for a secure, reliable installation. The control port
module supports DIN rail installation, and features four relay outputs plus four sensor inputs. The inputs and outputs
are both configurable for various operating modes.
1 x AT-VCC
1 x AT-VCC-RELAY
Introduction
Features
Package Contents
•
Provides conversion between IP and relay / sensor control signals for the Velocity Control System
•
Compact form factor – inconspicuous and easily concealable
•
Easy to set up and configure using the Velocity Control Suite
•
Remotely powered via PoE (Power over Ethernet)
•
Also can be powered through USB from a nearby USB power source
•
Primary unit installs onto any surface via a convenient mounting dock – simple “click” locks device into place
• Control port module includes four relay outputs and four sensor inputs
•
Relay outputs configurable to support common relay types – Single Pole Single Throw (SPST), Single Pole
Double Throw (SPDT), and Double Pole Double Throw (DPDT)
•
Sensor inputs can be configured to support voltage or contact closure sensing
•
Push-in terminal blocks for relay and sensor connections
•
4.5 foot (1.4 meter) cable
• Control port module supports DIN rail installation
•
Award-winning 10 year limited product warranty
•
The Velocity Command Converter must be on the same network as the Velocity Gateway (AT-VGW-250) or it will
be unable to sync for control.
•
The AT-VCC-RELAY-KIT is PoE, to power the unit, simply plug it into a PoE compatible network switch. If the
network switch is not PoE capable, a PoE injector (purchased separately) or USB can be used.
•
All devices (AT-VCC, Velocity, AT-VTP, switchers, etc) should be set to static IPs or the DHCP IP address reserved
for each individual device.
Operating Notes
IMPORTANT:
Velocity Gateway (AT-VGW-250) must be set up before the AT-VCC-RELAY-KIT is fully
functional.
