AT-OMNI-111 / AT-OMNI-112
41
Key
Enter the scrambling key in this field. The scrambling key must be ASCII and must contain a minimum of eight
characters. Special characters and spaces are not permitted.
Encoder (Video)
Select the desired encoder stream from this drop-down list. Refer to the
Encoding
tab for basic configuration of the
encoder stream.
Enabled (Video)
Click the
Enabled
check box to enable the video stream. To disable the video stream, uncheck this box.
By default, video streaming is
enabled
. Disabling the video stream can be used to “mask” the video on several
decoder endpoints.
Destination IP Address
Enter the IP address that will be used by the decoder endpoint. By default, AMS will automatically populate
multicast IP addresses for the encoder.
Destination UDP Port
Enter the UDP port in the
Destination UDP Port
field.
TTL
Set the
TTL (Time-To-Live) duration, from 1 to 255 seconds, in this field. The default value is 255 seconds.
DSCP
Select the Differentiated Services Code Point (DSCP) type from the
DSCP
drop-down list. This value will be used to
determine the Quality of Service (QoS) on a network. The available values are: Best Effort, Low, Normal, High, and
Highest. The Best Effort setting will provide normal priority for data packets, while a setting of Highest will prioritize
data packets as critical. However, it should be noted that a higher priority setting may also result in high data packet
loss, depending upon network traffic.
FEC Enable
Check this box to enable Forward Error Correction (FEC). This feature can be used when transporting streams over a
network that is suspected to be unreliable, due to noise or other factors. By default, this check box is checked. Refer
for more information.
FEC rows
Specify the number of FEC rows in this field. Refer to
for more information.
FEC Columns
Specifiy the number of FEC columns in this field. Refer to
for more information.
The AMS Interface
