AT-OMNI-111 / AT-OMNI-112
43
Source
Select the auxiliary data stream from the
Source
drop-down list.
Enabled
Click the
Enabled
check box to enable the auxiliary stream. To prevent data from being sent over this channel,
uncheck this box. By default, this feature is
disabled
.
Destination IP Address
Enter the endpoint IP address in the
Destination IP Address
field.
Destination UDP Port
Enter the UDP port in the
Destination UDP Port
field.
TTL
Set the
TTL (Time-To-Live) duration, from 1 to 255 seconds, in the
TTL
field. The default value is 255 seconds.
DSCP
Select the DSCP (Differentiated Services Code Point) type from the
DSCP
drop-down list. This value will be used to
determine the Quality of Service (QoS) on a network.
RTCP Enable
Click this checkbox to enable RTCP. RTCP is used to monitor Quality of Service (QoS) and provides synchronization
of data streams in multicast mode.
Bidirectional
Click this checkbox enable bidirectional serial control. This option only works when the data stream is in unicast
mode.
Listen Port
Enter the listening port for the data channel in this field, when using bidirectional serial control.
The AMS Interface
Source
Description
Commands
Commands are sent using CEC (over HDMI)
serial_port1
Commands are transmitted using Serial Port 1
serial_port2
Commands are transmitted using Serial Port 2