AT89STK-09 User Guide
1-2
7521B–SCR–10/05
Section 1
Introduction
This document helps the user to get started with the AT89STK09 starter kit.
The AT89STK09 is a starter kit for the AT83C26 device. The AT83C26 is a smart card
reader interface with 2 DC/DC converters allowing to manage up to 5 smart cards
including level shifters. This device needs TWI commands to configure its registers. This
device requires a host microcontroller (Smart Card Reader Microcontrollers, ARMs, ...)
with one or two ISO7816 Smart Card Interfaces.
Refer to the AT83C26 datasheet for further product information.
1.1
Acronyms
•
TWI : Inter Integrated Circuit
•
SCIB: Smart Card Interface Bus
•
LDO : Low Drop Output (Regulator)
1.2
Features
The AT89STK-09 Board provides the following features:
•
AT89STK09 board with 2 ISO7816-3 connectors and 4 SIM/SAM connectors
•
2 Gemplus GemClub Smart cards
•
One 20 multicolor wires cable with HE10 connector
•
Smart Card Reader IC CDROM (from may 2005)
•
2 VQFP48 & 2 QFN48 samples
•
AT89STK09 user guide document
The AT89STK09 board allows a large number of hardware configurations.
Summary of Contents for AT89STK-09
Page 1: ...AT89STK 09 Starter Kit for AT83C26 User Guide...
Page 12: ...Schematics Bill Of Material 4 11 AT89STK 09 User Guide 7521B SCR 10 05...
Page 13: ...Schematics Bill Of Material AT89STK 09 User Guide 4 12 7521B SCR 10 05...
Page 14: ...Schematics Bill Of Material 4 13 AT89STK 09 User Guide 7521B SCR 10 05...
