36
Atmel AVR2052
8200M-AVR-11/11
10 Appendix A-4: UC3 specifics
10.1 Getting started
10.1.1 Required hardware
Before installing and using the Atmel BitCloud SDK for the Atmel 32-bit AVR UC3,
make sure that all necessary hardware is available:
1. Two or more Atmel EVK1105 boards
2. Two or more radio extender boards
3. Connectors for each EVK1105 board:
a. Five two-wire cables
b. One USB 2.0 A/Mini-B cable
4. Atmel AVR JTAGICE mkII or Atmel JTAGICE 3
10.1.2 Hardware setup
To prepare the hardware:
1. Install the J12 and J16 extension headers on the board (if not already installed).
2. Install the JTAG pin header on the board (if not already installed).
3. Use several two-wire cables to connect J16 pins to the corresponding pins on the
REB231 boards, as indicated in
Table 10-1.
EVK1105 to radio extender board REB231 pin mapping.
EVK1105 J16 pin
REB231 pin
1
30
2
29
3
28
4
27
5
38
6
26
8
25
9
22
10
20
10.1.3 System requirements
Before using the SDK, please ensure that the following system requirements are met
by your PC and development environment.
Table 10-2.
System requirements for UC3.
Parameter
Value
Note
CPU
Intel Pentium III, or
higher, 1GHz
RAM
512MB
Free space on hard disk
200MB
