At 4009 / N
V.10.2010
13
3.
ELEKTRICKÉ ZAŘÍZENÍ KOMPRESORU
COMPRESSOR ELECTRICAL EQUIPMENT
ELEKTRISCHE EINRICHTUNG
3.1.
POPIS ELEKTRICKÉHO ZAŘÍZENÍ
DESCRIPTION OF ELECTRICAL EQUIPMENT
BESCHREIBUNG DER ELEKTROANLAGE
Kompresor se připojuje na třífázovou proudovou soustavu 3/N/PE
AC 400/230V, 50Hz.
(viz. schéma elektrického zapojení)
Přívodní kabel zakončený vidlicí 16 A (nebo 32 A) je připojen
přímo do hlavního vypínače kompresoru.
Kompresor je poháněn asynchronním elektromotorem s kotvou
nakrátko.
Výstraha !
Elektrické zařízení kompresoru je pod napětím i při
vypnutém “Hlavním vypínači”. Při práci je nutné vypnout
externí hlavní vypínač nebo kompresor odpojit od el. sítě
vytažením přívodu ze zásuvky.
Kompresor je vybaven frekvenčním měničem, který zajišťuje
rozběh a změnu otáček hlavního elektromotoru. Frekvenční
měnič zajišťuje plynulou změnu výkonu kompresoru podle
okamžité spotřeby stlačeného vzduchu.
Upozornění !
Frekvenční měnič není přizpůsoben pro napájení s
doplňkovou ochranou proudovým chráničem. Pokud je
instalován proudový chránič, dochází při některých
provozních stavech měniče k jeho aktivování.
Poznámka :
S frekvenčními měniči lze použít pouze speciální proudové
chrániče, určené k tomuto účelu.
Pro další informace kontaktujte výrobce kompresoru nebo
frekvenčního měniče.
The compressor set is connected to the 3/N/PE AC 400/230V, 50Hz.
(see electrical circuit diagram)
The supply cable furnished with a terminating plug plug 16 A (or
32 A) is connected directly to the compressor main switch.
The compressor is driven by an asynchronous electromotor with
short-circuit armature.
Warning !
Electric equipment is under power even if the "Main switch" is
off. In course of maintenance activities must be external main
switch off or disconnect compressor by supply cable take out
from power net.
Die Schaltanlage wird in Netz 3/N/PE AC 400V/50Hz angeschloßen.
(siehe Schema der Elektroinstallation)
Zuleitungskabel mit 16 A-Gabel (oder 32 A) ist direkt in der Schaltanlage
angeschlossen.
Der Verdichter wird von einem asynchronen Elektromotor angetrieben.
Der automatische Betrieb im eingestellten Bereich für den Betriebsdruck
sichert der Druckschalter des Kompressors.
Warnung !
Bei ausschaltenem Hauptschalter ist die Elektroeinrichtung unter der
Spannung. Bei der Arbeit wird die Elektroeinrichtung nötig von
Elektronetz durch externen Hauptschalter ausschalten oder die
Zuleitungskabel mit Gabel aus Steckdose ausziehen.