3-8
H. MOUNTING IR-450 TO THE ATN NVM-14
IR-450 may be mounted on the monocular through the Picatinny
adapter.
1. Install the Picatinny Adapter on one of the monocular rails
(See 3.1.F).
2. Loosen the IR-450 fixing screw.
3. Mount the IR-450 on the Picatinny Adapter and tighten the
fixing screw.
I. MOUNTING THE ATN NVM-14 TO THE pVS-7
HEAd/HELMET MOUNT
To mount the ATN NVM-14 to a head/helmet mount, perform the
following:
1. Attach the PVS- 7 headmount adapter (A) to the rail (B) of
ATN NVM-14.
With this adapter you may see through the eyepiece using either
right or left eye. To change the viewing eye, loosen the nut(C)
and turn the adapter(D) in the point of connection to match with
another eye. Tighten the nut(C) anew. To disconnect the adapt
-
er press the upper clip(E).
2. Align the headmount adapter and the head/helmet mount.
Slide the monocular rearwards until the alignment boss aligns
with the alignment groove on the head/helmet mount. Push un
-
til the monocular locks into the head/helmet mount.
Figure 3-9
Attaching ATN NVM-14 to pVS-7 Adapter
A
B
C
d
E
Summary of Contents for Multi Purpose Night Vision NVM14-3
