3
to change the position of the riflescope on the weaver rail additionally follow the steps men-
tioned below:
1. Unscrew the two screws, which attach the rail to the
mounting bracket.
2. take the rail out of the groove.
3. about-face the rail in case of necessity.
4. place the rail into another groove.
5. Fix the rail with the two screws.
NOTE:
If the rail does not come out easily, tighten one of the removed screws into the threaded
aperture in the middle of the fixing projection of the rail. Rotate this screw, which will in turn push
the rail out from the groove.
conTRol
the night arrow 2 has a simple and easy to operate one-knob control and adjustment.
To turn riflescope on rotate the operation knob from position marked “0”.
To turn riflescope off rotate the operation knob to position marked “0”.
after turning scope on, you may adjust the reticle’s brightness by rotating the operation knob
from position marked “1” to position “9”. Position “1” corresponds to the minimal brightness,
the position “9” corresponds to the maximal brightness of reticle’s glow.
adjustment could be easily seen if you look through the scope while adjustment.
FocusIng
to focus your riflescope you will need to adjust the diopter. Simply turn the diopter clockwise
until it stops. then, while looking through the diopter at a subject, slowly turn the diopter back
counter clockwise until the grain in the image is sharp.
NOTE:
We suggest that you focus the diopter during daylight with the cap on.
opERATIon ExTEnDIbIlITy
there is picatinny rail on the body of the scope for additional lighting, laser and other mission
critical tools.
IR IllumInATIon
Infra-red (Ir) Illuminators are common for night vision technology. the Ir light greatly
enhances the performance of your night arrow 2 scope, while remaining almost totally invis-
ible to the naked eye. In dark environment, power up the atn night arrow 2. now, find a scene
and examine it without the Ir on then with Ir powered up. note the difference in illumination. It
is important to remember that the Ir illuminator is simply an infra red light source, and like any
light source it may loose its effectiveness over a great distance.
to fix the Ir illuminator to the riflescope use the picatinny raile of the scope.
the Ir illuminator control buttons are located on its side. to switch the Digital Ir illuminator
on/off press “+” and “-” buttons simultaneously. When the IR illuminator is switched on you can
see the green LED lit. By pushing the buttons “+” and “-” you may adjust the IR brightness.
Ir Brightness
adjustment
Battery
housing
Fixation
Screw
Ir elevation
Ir windage
Ir Focusing
nut
Groove
rail with a
fixing projection
Screws
mounting
system
