4
the Ir beam is focusable to change the field of coverage. to change the beam width slightly
turn the Ir lens.
You could change the IR control panel fitting your needs. The wrench included into the set
should be used for weakening the fixing nut located on the Ir. rotate the Ir placing at in the
most convenient position. tighten the nut with the wrench to fix the new position.
RETIclE
the night arrow 2 reticle gives a clear aiming point, even when
hard-to-see targets blends into the background. thin posts and
center crosshairs cover a minimum of the target and allow for
less target coverage, making precision shots on small targets
easy.
Lit center section of crosshairs have an adjustable brightness
to lead your eye directly to the center and aiming position. the
result is fast precision target acquisition.
wInDAgE AnD ElEVATIon
the vertical and horizontal adjustments for the night arrow
2 can be achieved by turning the elevation and windage
adjustment mechanisms (remove dust caps first). each
click equals 1/2 inch at 100 yards. when reaching the
maximum range of rotation do not use force.
clEAnIng ThE opTIc suRFAcEs
You may need to clean the optic surfaces of the riflescope from time to time in order to guaran
-
tee top performance. when you receive your riflescope you should check for dust on the optic
surfaces of the unit.
CAUTION:
Use only Photographic lens cleaning tissue on these surfaces. Be careful not to
scratch or smudge any of these surfaces. When using compressed air to blow dust away, make
sure to avoid inverting the can while spraying. This can cause frozen propellant to exit the can,
which can cause serious problems with the glass and phosphor screen
.
windage
elevation
Illuminated
red center
section
