4
off, you may focus the front lens to obtain the sharpness of the image, leaving the diopter
adjustments unchanged.
NOTE:
The front lens may be readjusted as you view objects at different distances.
InfRA-RED IllumInAToR
Infrared illuminators, or IR illuminators, are common for night vision. The IR light greatly
enhances the performance of the NVB8 while remaining almost totally invisible to the
naked eye.
The NVB8 have a built-in IR with indicator
“ON” within the FOV. To turn the IR on,
hold the button pressed for more than 1.5
sec. It is important to remember that the IR
illuminator is but an infrared light source,
and like any light source, it may loose its
effectiveness over a great distance.
To turn the IR off, again hold the button
pressed for more than 1.5 sec.
NOTE:
The IR will automatically turn off when the unit’s power is off.
450 mw InfRA-RED IllumInAToR
The 450 mW IR Illuminator is powered
with is own separate battery. To install
the battery unscrew the cap and insert
the battery the way shown on the polar-
ity diagram.
To mount the 450 mW IR Illuminator
onto the bi-ocular loosen the IR illu-
minator clamp, insert the IR rail the
bi-ocular mounting bracket and tighten
the clamp.
The IR illuminator control buttons are located on its top. Pressing “+” and “-” buttons
simultaneously works both to turn the Digital IR Illuminator on and to switch it off after-
wards. When the IR illuminator is switched on you can see the green LED lit. By pushing
the buttons “
+” and “-” one by one you may adjust the IR brightness.
The IR beam is focusable to change the field of coverage. To change the beam width
slightly turn the IR lens.
You may change the IR control panel fitting your needs. The screw-tool from the kit is
used to loosen the clamp located on the IR. Rotate the IR to the most convenient position.
Tighten the clamp with the screw-tool to secure it in the new position.
Built-in IR illuminator
Battery
Housing
Clamp
Elevation
Windage
IR Focusing
IR Brightness Adjustment
