2-4
2.2. ASSEMBLY
2.2.1. ExTERNAL POWER SOURCE
WARNING
When the unit is to be powered with external sources, first make
sure the batteries have been taken out.
As an external power source, a standard network controller with
outer voltage of 6v and current of over 0.5A can be applied. To
connect an external source recommend to use a 6 mm standard
double-pole socket in the way the positive contact is the central
contact.
Use the video cable to connect an external 6 vDC/ 1 A power sup-
ply to the oTS-10.
Connect an external power supply to the monocular as follows:
1. remove the batteries.
2. remove the protective cap from the monocular output con-
nector socket.
3. Attach the video cable to the output connector socket.
4. Attach the power jack socket of the cable to a 6 VDC/ 1 A
power supply.
NOTE
1. The external power supply plug must have a 6 mm oD con-
tact with center pin positive.
2. Avoid a sudden removal of power source: use the power
button «oN/oFF» to turn the monocular off before you remove
batteries or disconnect external power supply.
3. replace the protective cap on the monocular output connec-
tor socket after disconnecting the cable.
2.2.2. VIDEO OUTPUT
The oTS incorporates a sealed Connector used for video trans-
mission and to connect external power sources. video Cable at-
taches the scope to the video facilities for video recording or video
Summary of Contents for OTS-15
