SAFETY AND MAINTENANCE MANUAL
1NO0024UK-09
47
Fig 3
Fig 4
1.3. ARM AND ASSOCIATED CYLINDER
The arm, tie rod and cylinder articulations are assembled with
self-lubricated collars. Even if no upkeep is necessary, one must
however control the cylinder rod:
- possible presence of rust
- possible presence of scratches in which case there is a risk of
wear of the seals, therefore leaks.
- possible presence of leaks in which case it is imperative to
change the seals.
As for the replacement of collars, use an adequate tool.
Do not strike the collar directly, this could cause subsiding of the
material, and therefore premature wear of the collar.
1.4. BASKET AND BASKET SUPPORT
1.4.1 BASKET
The machine is fitted with a free-standing basket. Its rapid disassembly
without dismantling the hydraulic or electric controls is in fact a major
advantage.
No specific upkeep is needed.
DISMANTLING OF THE BASKET
- unscrew the 4 locknuts of the U clamps and remove the (Fig.1).
- disconnect the validation pedal.
- lift the basket (Fig.2).
- tilt the basket so as to release the latter from the hydraulic and electric
controls so as to avoid damaging these when removing the basket (Fig.3
and 4).
REASSEMBLY OF THE BASKET
- tilt the basket so that the controls are well in place.
- lower the basket.
- place the U clamps on the basket by pushing flat against its support and
tighten moderately.
- centre the basket vis-à-vis
the support and tighten the
basket.
- reconnect the validation
pedal.
- control the precision of the
"stress gauge" overload limiter
and re-adjust the limiter if
necessary
(cf. Chap II § 1-4-2 Basket
support).
Fig 2
Fig 1
Summary of Contents for PIAF 1000R
