4
RETIclE
ATN Trident Pro reticle gives a clearly aiming point, even
when hard-to-see game blends into the background. Posts
and crosshairs center section covers a minimum of the
target and allow for less target coverage, making precision
shots on small target easy.
The size of illuminated red reticle correspond to 1 yards at
100 yards distance.
IR Brightness
Adjustment
Battery
Housing
Fixation
Screw
IR Elevation
IR Windage
IR Focusing
that the IR illuminator is simply an infra red light source, and like any light source it may loose its
effectiveness over a great distance.
To fix the IR illuminator to the riflescope use the picatinny raile of the scope.
The IR illuminator control buttons are located on its side. To switch the Digital IR illuminator
on/off press “+” and “-” buttons simultaneously. When the IR illuminator is switched on you can
see the green LED lit. By pushing the buttons “+” and “-” you may adjust the IR brightness.
The IR beam is focusable to change the field of coverage. To change the beam width slightly turn
the IR lens.
You could change the IR control panel fitting your needs. The wrench included into the set should be
used for weakening the fixing nut located on the IR. Rotate the IR placing at in the most convenient
position. Tighten the nut with the wrench to fix the new position.
wIndAgE And ElEVATIon
The vertical and horizontal adjustments for the
ATN Trident Pro
can be achieved by turning the elevation and windage adjust-
ment mechanisms (remove dust caps first). Each click equals
1/2 inch at 100 yards. When reaching the maximum range of
rotation do not use force.
clEAnIng ThE EyEpIEcE
You may need to clean the eyepiece of the riflescope from time to time in order to guarantee top per-
formance. When you receive your riflescope you should check for dust on the eyepiece of the unit.
CAUTION:
Use only Photographic lens cleaning tissue on these surfaces. Be careful not to scratch
or smudge any of these surfaces. When using compressed air to blow dust away, make sure to avoid
inverting the can while spraying. This can cause frozen propellant to exit the can, which can cause
serious problems with the glass and phosphor screen
Windage
Elevation
Windage
Illuminated
red reticle
Nut
