3
To change the position of the riflescope on the weaver rail
additionally follow the steps mentioned below:
1. Unscrew the two screws, which attach the rail to the
mounting bracket.
2. Take the rail out of the groove.
3. About-face the rail in case of necessity.
4. Place the rail into another groove.
5. Fix the rail with the two screws.
NOTE:
If the rail does not come out easily, tighten one of the removed screws into the threaded
aperture in the middle of the fixing projection of the rail. Rotate this screw, which will in turn push
the rail out from the groove.
DIgITAl coNTRol
The
ATN Trident Pro
has a simple and easy to operate one-button control and adjustment.
To turn on:
Press the operation button by one short push
To turn off:
Press the operation button again by one short push
To adjust reticle brightness:
1) After turning scope on, press and hold operation button. Brightness will grow smoothly while the
button is kept pressed. Release the button when necessary brightness is achieved.
2) Press and hold the button second time for smooth decrease of brightness. Adjustment could be
easily seen if you look through the scope while adjustment.
All functions of digital control are available with remote control also.
focusINg
To focus your riflescope you will need to adjust the diopter first thing. Simply turn the diopter clock-
wise until it stops. Then, while looking through the diopter at a subject, slowly turn the diopter back
counter clockwise until the grain in the image is sharp.
NOTE:
We suggest that you focus the diopter during daylight with the cap on.
oPERATIoN EXTENDIbIlITy
There are three detachable Picatinny rails on the body of the
scope for additional lighting, laser and other mission critical
tools. The rails fix with two screws as shown on the figure.
IR IllumINATIoN
Infra-red (IR) Illuminators are common for night vision technology. The IR light greatly enhances the
performance of your
ATN Trident Pro
scope, while remaining almost totally invisible to the naked
eye. In dark environment, power up the
ATN Trident Pro
. Now, find a scene and examine it without
the IR on then with IR powered up. Note the difference in illumination. It is important to remember
that the IR illuminator is simply an infra red light source, and like any light source it may loose its
effectiveness over a great distance.
To fix the IR illuminator to the riflescope use the picatinny raile of the scope.
The IR illuminator control buttons are located on its side. To switch the Digital IR illuminator
on/off press “+” and “-” buttons simultaneously. When the IR illuminator is switched on you can
see the green LED lit. By pushing the buttons “+” and “-” you may adjust the IR brightness.
The IR beam is focusable to change the field of coverage. To change the beam width slightly turn
the IR lens.
Grooves
Rail with a
fixing projection
Screws
Mounting
system
