Page 16/28 (26/21)
• In the next step, attach the battery pack
(6) to the base. On the underside of the
battery pack, is a plastic clip (4) which is
put on the base (5) of the Variabel III and
with slight pressure to the upper side of
the battery is locked into place.
• Then fasten the connection module (8)
underneath the battery pack with two
pieces of the enclosed cable ties (7) as
shown on the picture. Thereby make sure
that the module sits tightly.
• Now insert cables of motor and hand
control into the connection module. Pass
the cable of the motor through the clevis
of the motor mounting. Ensure to lay
the cable of the motor, so it cannot be
squeezed through the motor fastening.
• Finally, the connecting lead cable of the
battery pack is guided along below the
connection module and at the right end
of the connection module tied together
with the cable for the connection of the
hand control by using a cable tie.
• After completed assembly check again
that the connection module and the
battery pack are tightly mounted and also
check the mounting points of the motor
to ensure a safe use of the complete
device after the conversion.
Assembly and adjustment
6
4
5
8
7
