SDA300 Sig
ATOLL ELECTRONIQUE
Page 7
6 - USES
GETTING STARTED
Before Switching On your appliance, connect the network cable (RJ45) to input (11). For much better results
and best performances, we highly recommend to uses a wired connection better than a WIFI connection.
Wait for the start-up screen to appear before any manipulation.
You can use the buttons of navigation (17) of the remote control or the front panel to select the different menus.
On the first connection (or changes in the network configurations) you will have to check the network settings
of your appliance. If this setup is not perfectly settled, some of the functions of the streamer (internet radios or
reading music of your server) will not be operated.
Available menus:
– Playlists.
– Internet radio.
– USB.
– Media Server.
– Qobuz.
– Tidal.
– Deezer.
VOLUME :
The volume is managed using the buttons (21) on the front panel or the remote control.
The volume level is displayed for a few seconds on the display, and it always remains indicated at the top of
the display.
On start-up, the volume is still the one that remained previously.
Volume at zero corresponds to a complete “MUTE” of the device with switching of the output relay.
5 - PREAMP / BYPASS FUNCTIONS
SOURCES :
Your appliance has 6 inputs (unless USB, media server, Bluetooth®):
Line 1 / Line 2 / Coaxial 1 / Coaxial 2 / Optical 1 / Optical 2
These sources can be renamed from the
ATOLL Signature
application: Settings/Rename local inputs.
NB. : the selected source is always followed on the screen by a symbol
*
.
CONNECTION
:
Particular case
: BYPASS assignment of an input for connection to a home cinema system.
Entry into BYPASS function is only possible on Analog inputs 1 and 2.
In this case, the volume management function is inoperative on the selected input.
To switch to this mode, position yourself on Analog input 1 or 2 then hold the BYPASS button (39) on the
remote control for 3 seconds. When the BYPASS is active, the led (22) is on.
When an input is selected in BYPASS mode, it will remain memorized in this mode even if the source is
changed or the power is turned off.
To deactivate this mode, press the BYPASS button on the remote control for 3 seconds.
– HighResAudio.
– Spotify.
– Bluetooth.
– Analog 1 and 2.
– Coaxial 1 and 2.
– Optical 1 and 2.
– Settings.
NETWORK CONFIGURATION:
1- Go to the “Settings” menu then to “Network connection”.
2- Select the “Network Wizard” menu.
3- You will have to choose the type of network. Press “
Network type
” and choose “
Automatic
”, “
Wired
”,
“
Wireless
” or “
Hybrid
”.
Connecting an RJ45 cable automatically launched the network link. If this is done correctly ( not
blinking), your network is correctly configured. The following paragraph is optional in your case.
