6
2 - CONNECTINGS SETUP
SOURCE
MODE
OR
PREAMPLIFIER
(B
Y
-P
ASS
)
This device can be use as a source (like a CD player) or as a preamplifier which gives ability to control the
volume.
Schemes below shows how to connect correctly depending of your choice.
ST200
Signature
Source
Preamp
Integrated IN200 type
Amplifier AM200 type
TRIGGER
LINK
This appliance is equipped with a Trigger that allows the switch ON/OFF of any amplifier equipped with the
same kind of trigger inputs (amplifier ATOLL AM200se).
Appliances must be linked as shown below:
Streamer ST200 Sig.
Amplifier AM200se
In order that the system is operating, the ON/OFF button of your AM200se must remain in position OFF
(position (0)). If the switch is in the ON position (I), the amplifier will work but not the Trigger function.
Trigger cable must be a Male to Male STEREO jack plug 3.5mm (1/8”)
Using ST200 Signature as a source
directly linked to an Integrated or
preamp.
By-pass mode should be
active and the By-pass led (16)
switch on.
Using the Streamer as a preamplifier
directly connected to a power amplifier
(or active speakers).
By-pass mode
should be not active and By-pass
led (16) off.
