7
3 - USES
Starting:
Before switching On your appliance, connect the network cable (RJ45) to switch (10).
For much better results and best performances, we highly recommend to uses a wired connection better
than a Wifi connection.
While started, wait for display switch on.
You can use the buttons of navigation (17) of the remote control or the front panel to select the different menus.
On the first connection (or changes in the network configurations) you will have to check the network settings of
your appliance. If this setup is not perfectly settle, some of functions of the streamer (internet radios or reading
music of your server) will not be operated.
Menus available are:
I - SETTINGS
Network Configuration:
Note
: Network configuration starts immediately when a RJ45 cable is linked (11).
Select « Settings » and then « Network Wizard ».
You’ll have to select the type of network you need. Press « Network Type » and select « Automatic » « Wired »
« Wireless » or “Hybrid”.
1/ WIRED
If you already plugged the network cable, the device will indicate than the appliance is connected and
the symbole
will be shown on the display.
If not, configure the network while choosing “Configure Wired” and then “Manual”. Here you can enter directly the
IP address.
